Return the result code of the previous action.
Syntax
object.ResultCode
Remarks
The ResultCode read-only property returns the result code
of the last action performed by the client. This property should be
checked after the Command method is used to execute a command
on the server to determine if the operation was successful. Result
codes are three-digit numeric values returned by the server
and may be broken down into the following ranges:
| Value |
Description |
| 100-199 |
Positive preliminary result. This indicates that the
requested action is being initiated, and the client should
expect another reply from the server before proceeding. |
| 200-299 |
Positive completion result. This indicates that the server
has successfully completed the requested action. |
| 300-399 |
Positive intermediate result. This indicates that the
requested action cannot complete until additional information
is provided to the server. |
| 400-499 |
Transient negative completion result. This indicates that
the requested action did not take place, but the error
condition is temporary and may be attempted again. |
| 500-599 |
Permanent negative completion result. This indicates that
the requested action did not take place. |
It is important to note that while some result codes have become
standardized, not all servers respond to commands using the same
result codes. For example, one server may respond with a result code
of 221 to indicate success, while another may respond with a value of
235. It is recommended that applications check for ranges of values
to determine if a command was successful, not a specific value.
Data Type
Integer (Int32)
See Also
ResultString Property,
Command Method,
OnCommand Event
|